Re: v3re подскажите testpoint
#4
Вот такой кабель вам понадобится
Ниже привожу полный мануал по разлоку с форума MSS:
Код:
1. Power on your phone without a simcard and Connect your phone to MSS Box thru an original USB cable (e.g. the one that you use to flash with RSD Lite or to connect with mobile phone tools) DON'T USE the one that comes with mss box and have an extra cable with a needle (because is a powered cable to make testpoint in lte, lte2 and linux phones) AGAIN DON'T USE the cable with the needle.
2. When the phones is detected by mss box (the phone's information is displayed) click in Service tab (a submenu is displayed) click in Unlock and at the right click in Start, the program will start the procedure.
3. when this message appears ---""If phone will not power up within 10 seconds, please, reconnect phone cable (and battery if used). If phone will not power up after this, turn on phone in flash mode manually (*, #, PWR)""--- just put your phone in flash mode pressing * # power, but don't disconnect it, then the program will continue with the procedure.
4. When these messages appear ---""Phone is powered off
Please disconnect phone and connect battery hook (adapter version 3) and not powered (original) USB cable""--- disconnect the USB Cable and remove your battery or whaterever you use to supply power to your phones.
5. Disassemble your phone and remove the shield CAREFULLY to clear the testpoint area marked at the testpoint picture with the instrument of your choice, dremel, cut pliers, Plato shears. etc... CAREFULLY. When you already have done this continue with the next step.
6. Connect the MSS Box TP (AT163) to MSS Box, the adapter that have an RJ-45 connector at one end and at the other:
Red cable with a hook ( + to the battery conector)
Black cable with a needle (- to the testpoint) (BUT NOT negative for the battery connector, AGAIN this is NOT a negative for the battery connector)
Yellow cable with a needle (+ to the testpoint) (BUT NOT positive to the battery connector, AGAIN this is NOT a positive for the battery connector)
p.s. not to confuse with another testpoint adapters like BB5 or others.
7. Connect the red cable with the hook to the phone's battery (+) connector and connect the original USB Cable to the phone.
8. When these messages appear ---""Phone found. Continue...
Please connect special testpoint""--- connect the black cable's needle to the testpoint marked at the picture and press lightly but not too strong and hold it, then touch this needle with the one in the yellow cable and hold them
NOTE: In w490, w510 and W5 you must connect the neddles at different testpoints, never touched between them (clearly marked in the testpoint pictures).
9. This message must appear ---""Please hold testpoint connected...""--- (if it doesn't happen, repeat the step eight) if all is going correctly this message will appear ---""Please disconnect special testpoint""--- then disconnect both cables and let the program to finish the unlocking procedure.
10. If this message appears ---""Complete""--- Congratulations you have successfully unlocked your phone.
Последние файлы
