Re: Не прошивается simbian в P900i
#4
Тема старая и уже разжевана .
Для тех кто не знал :
Cruiser P910i Flashing
Oh bugger it, I've drunk enough beer and debugged enough BGP problems tonight to not care about sleeping, so here's a detailed guide. Any mistakes are due to how much beer I've drunk (a lot)
Make sure you have a fully charged battery or the beer gods will get angry!!!
Turn off the phone and attach it to the cable.
In Cruiser/Fighter (called Cruiser from now on for ease of typing) make sure Standard (wait) is selected (it's the default) and attach to the phone.
Flash (
http://microengineers.cc/cruiser/sup...0_cR4A10/Phone)
to the phone, using the Flash AVR option in the Flash Tab (be sure to unrar the file first!)
Once that's flashed happily, detach the phone in Cruiser. Remove the phone's battery and replace it. This time in the Primary tab of Cruiser select P80x/P90x (PDA-part) option. Now Click Attach To Phone again. You'll notice it's an instant attach this time. THIS STEP IS IMPORTANT!
Ok, so now you're attached to the phone's PDA part you can flash the Symbian and UserData parts! This is where you get to decustomise the phone properly.
First, we're going to flash the Symbian part. Download
(
http://microengineers.cc/cruiser/sup...cR4A10/Symbian)
, unrar it and then in the Flash Tab click on Flash PDA and flash the image to the phone.
Nearly done!
Finally, go (
http://microengineers.cc/cruiser/sup...A10_cR4A10/CDA)
and download one of those files. Please read the Cruiser manual for which one you want (basically they're just different language packs)
Once you've got the flash file you need, unrar it and then click on our friend Flash PDA again and pick the file you just unrar'd.
Once this is done, go back to the Primary Tab in Cruiser and Detach the phone (or Turn off phone if that option is available, I don't think it is though but I forget)
Power on your P910i! You'll have a totally blank, factory fresh unbranded P910i.
Please please do not make the same mistake so many people seem to make, they attach to the AVR part of the phone then flash the Symbian image to it. This will damage the phone. You need to be sure you are attached to the PDA part before flashing Symbian or CDA.
Hope this helps you!
- A Drunk Muppet.
Edit number 2: If you get "invalid final response" messages after flashing Symbian/CDA parts, go into the settings of Cruiser then the baudrates tab and for P90x PDA part ARM change it from 921600 to 460800. Repeat the flashes and you'll have no problems.
Последние файлы
