Hello mates.. i started to use Unlocking Calypso +sb.. from 20 phones i have 14 done and 6 dead

Phones become dead.. after i desolder flash ic and ut it in V55 pcb.. flash ic is not detecting

Found Phone, Phone Info:

- Flash ID: 00 90 00 90
- Chip(0): Unknow

Read 0x04000000 - 0x05000000...Done!

but reading... dump is about 2mb wichn is too small for a working flash ic...

i put lash ic back to phone.. off course phone not power up..

MY IDEA:
i use for cid52 unlock emty flash ic.... i think in hcina possible to find emty flash ic... but they need to be programed.. i have universal programer so i not have ny problem with this... problem is next:

In sagem we have imei in cpu + flash.. i need dump editor to be able to change imei in dump to original one.. can somebody tell is it possible to make my idea or not?! if yes maybe support team can provide us this soft to edit dumps . to edit imei.. maybe i am wrong and we need to chnge not only imei?!?!?


Thank u for help.. hope i have a good answeer ) becuase really we need to repair our phones.. problem in my phones 1000%%% in flash ic.. pcb is good.. on flash programator when i make test shows bad flash oc.. i think to bug temperature i use.. but i can desolder on lower temperature..

Чтобы восстановит телефон тебе надо знать DIE ID проца либо Crypted ID из родной флэшки. Насколько я понял, первое - недоступно, второе утеряно.

Тема в помойке. Надеюсь, не нужно объяснять почему?