После прошивы тело невкл. RPL незаливаеться :
COM6 selected
Device: Autodetect
Checking data, wait...
Action: Read information
Boot...
Press and HOLD Power button now !
baud autodetection active
19200
Connecting, wait...
Initializing[6226:8A02]...
Release Power button now !
Boot Done
Initialize...
detecting chip[00] in region[00]...
flash: 01227E22202200
flash: FFFFFF00000000
flash: Amd PL127J D 16Mb
number of flash chip/regions detected: 01/01
Initialize Done
Set baud...
230400
Set baud Done
Check space...
operation mode: Fast detection mode
device parameters autodetection in progress..
detecting chip[00] in region[00]...
flash: 01227E22202200
flash: FFFFFF00000000
flash: Amd PL127J D 16Mb
number of flash chip/regions detected: 01/01
total flash region size: 01000000
detecting eeprom area in 1 chip(s)...
flash: 01227E22202200
flash: FFFFFF00000000
checking area[00000000]: 00000000-00FFFFFF...
eeprom found near: 00E00000
detecting eeprom size...
eeprom size: 00200000
eeprom chip: 00
eeprom area detected[00000000]: 00E00000-00FFFFFF
detect device identification, method #1...
detection phase #1...
.
detection phase #2...
.................................................. ..............
warning: device identification detection failed, no any information found.
possible reasons:
. old firmware type w/o identification data
. wrong firmware
. damaged firmware
Finished, time used: 33 sec
Remove/Install battery now !