V3i висит на заставке после PDS-repair и full
#1
Телефон после неудачной прошивки. Писал что-то вроде Code corrupt.
Я сделал ему PSD repair, пролил фулл.
В итоге телефон включается, но зависает на заставке Hello Moto.
Цитата:
Searching for phone... found S Flash Neptune LTE2, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... A.30
Sending boot... OK
Erasing flash memory OK
Sending firmware OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Reading phone boot version... 3.00
Reading flash id... ST - M30L0R8000B0
Reading flash id/2... ST - M58LR128FT, OK
Phone group: V235,V360,V360v,V3i,V3r,L7,L7v,K1
Hardware IMEI: 358xxxxxxxxxxxx
Security area saved to "PDS for S Blank Neptune LTE2 358xxxxxxxxxxxx (14).mbk"
Unlocking phone... OK
Now you should write flash into the phone
Login request... OK
Writing flash section 2 of 2... 100% (37.9 Kb/sec)
Restarting phone... OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
Repair PDS request... OK
Performing PDS repair... OK
Writing flash section 1 of 1... 100% (15.1 Kb/sec)
Please write a corresponding Full_flash file to phone to complete repair
Writing flash section 2 of 2... 100% (58.9 Kb/sec)
Flash completed!
|