Samsung J710F добавить микросхему в Preloader/
#1
Привет. Прошу помочь добавить микросхему TYC0FH121638RA в Preloader
лог её
Цитата:
EMMC Device Information :
EMMC CID: 110100303034474530012A0BC87C812E
EMMC CSD: D05E00320F5903FFFFFFFFE7924000E2
EMMC Manufacture Name: TOSHIBA
EMMC Manufacture ID: 0x11 , OEM ID: 0100
EMMC Manufacture Date: 8/2014 , Rev: 01
EMMC NAME: 004GE0 , S/N: 2A0BC87C , rev. 01
EMMC NAME (HEX): 303034474530
EMMC ROM 1 (Main User Data) Capacity: 3776 MB (0000EC000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 2048 KB (000000200000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 KB (000000080000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.6 (MMC 4.5, MMC 4.51)
Boot configuration [PARTITION_CONFIG]: 0x08 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: 004GE0_2A0BC87C_20171212_195050.extcsd
EMMC Init completed.
|