Z3X EasyJtag Box JTAG Софт версия. 2.1.0.0
Loading eMMC Addon Firmware... IO: 1800 mV
Box С/Н: 1001xxxxxxxxxxxx, ,Микропрограмма Вер.: 01.53
Напряжение подтяжки линии CMD :2464 mV
Напряжение активной линии CMD :2547 mV
HiPower™ mode is off!
eMMC Device Information
EMMC CID : 1501004E35585A4D4206B9B2CA4281B4
EMMC CSD : D02701320F5903FFF6DBFFEF8E40400C
Изготовитель eMMC: ID: 0015 , OEM ID: 0100
EMMC Date: 08/2014 Rev.0x6
EMMC NAME: N5XZMB , S/N: 3115502146
EMMC NAME (HEX): 4E35585A4D4200
EMMC ROM1 (Main User Data) Capacity: 3728 MB
EMMC ROM2 (Boot Раздел 1) Емкость: 4096 kB
EMMC ROM3 (Boot Раздел 2) Емкость: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.7 (MMC 5.0)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x48.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: N5XZMB_3115502146_20160427_1722.extcsd
Searching for partition tables...
Partitioning not detected...
Сделано.

Z3X EasyJtag Box JTAG Софт версия. 2.1.0.0
Skip loading eMMC Addon Firmware
Напряжение подтяжки линии CMD :2464 mV
Напряжение активной линии CMD :2547 mV
Reading 0x000040000000 bytes from 0x000000000000 ...ROM1 ( USER ROM)
Output file :E:\!!Phone_res\LG\LG-X145\EMMC_ROM9_N5XZMB_3115502146_00000000_40000000.bin
Retry reading adress 0x00089400 (Attempt #1)
Retry Success!
Retry reading adress 0x000C9A00 (Attempt #1)
Retry Success!
Retry reading adress 0x0010A800 (Attempt #1)
Retry Success!
Retry reading adress 0x0013C800 (Attempt #1)
Retry Success!
Retry reading adress 0x00161A00 (Attempt #1)
Retry Success!
Done. Read Speed: 782 kB/s