Re: Не удается восстановить Samsung S7250D
#4
Цитата:
Сообщение от Dimus
Прошил с boot файлами, перестал включатся. Восстановил boot в download не входит. Сделал полное стирание. Теперь boot не восстанавливается. Стиратся не хочет. Full влить тоже не дает. Подскажите пожалуйста в какую сторону копать. ТА чистый. Был полностью рабочий. были проблемы с звонками.
Resurrection:
Развернуть для просмотра
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.54
Selected Resurrector: [Samsung S7250D V1.0.4660.65212]
Connecting to the dead body...OK
Detected dead body ID: 0x07B3617F - CORRECT!
Set I/O Voltage reads as 3.01V, TCK Frequency is 8 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x8084/0x8084
Selected Resurrection Data for the NAND Chip with Page size = 4KB
Flashing the dead body...
ERROR: DCC Loader has reported Error Code = 0x30 (0x000000). Trying to recover...FAILED
ERROR: Failed due to multiple communication errors. Terminating at 0x000000000000 [свернуть]
Erase:
Развернуть для просмотра
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.54
Selected Resurrector: [Samsung S7250D V1.0.4660.65212]
Connecting to the dead body...OK
Detected dead body ID: 0x07B3617F - CORRECT!
Set I/O Voltage reads as 3.01V, TCK Frequency is 8 MHz
Settings Code: 0x14010B00000000000000000008000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x8084/0x8084
ERROR: Cannot Automatically Determine the Selected FLASH1 Chip's size. Terminating. [свернуть]
Попытка прошить full:
Развернуть для просмотра
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.54
Selected Resurrector: [Samsung S7250D V1.0.4660.65212]
Connecting to the dead body...OK
Detected dead body ID: 0x07B3617F - CORRECT!
Set I/O Voltage reads as 3.01V, TCK Frequency is 8 MHz
Settings Code: 0x34010B00000000000000000008000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x8084/0x8084
ERROR: Cannot Automatically Determine the Selected FLASH1 Chip's size. Terminating. [свернуть] |
Не факт, что флеша мертвая! Проверьте подключение, RTCK пробуйте выбрать другуЮ.