SHW-M250S (Korean i9100) JTAG pinout
#1
По резукекту что выдает RIFF нет конекта
нашел на просторах рабочий
Цитата:
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.80V, TCK Frequency is 1 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (VYL00M, 0x0003AB400000 Bytes = 14.68 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (VYL00M, 0x000000080000 Bytes = 0.50 MB)
Selected Resurrection Data for the eMMC Chip with Capacity = 14,68GB
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000004000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000008000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x00000000C000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000010000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000014000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000018000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x00000001C000 is handled as Cut Excess.
|