Open serial port...OK
 Connecting to the RIFF Box...OK
 Firmware Version: 1.32, JTAG Manager Version: 1.42
 Selected Resurrector: [Samsung N7000 AP V1.0.4458.16492]

 Connecting to the dead body...OK
 Detected dead body ID: 0x4BA00477 - CORRECT!
 Set I/O Voltage reads as 2.81V, TCK Frequency is 8 MHz

 Resurrection sequence started.
 Establish communication with the phone...OK
 Initializing internal hardware configuration...OK
 Uploading resurrector data into memory...OK
 Starting communication with resurrector...OK

 WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

 ERROR: Selected FLASH Chip was not initialized by the DCC Loader.