Connect phone on selected interface...

Core version : 1.24 , Rev : 2.0

Selected FlashSettings : 
Files Set for Flashing :
MCU : rm732_004.550
PPM : rm732_004.55ei
CNT : rm7320_nai04.55ei

Infineon flashing...
Booting phone now....
Sync Ok , A2
CPU ID : XGOLD , A200341100
PBL : Dynamic
Boot Ok , 01AB
SBL : Dynamic
Algo Ok , 01
SBL mode Ok
SBL : Default_RAM_Bootloader
EPP CFG [Bering]...
FLASH ID : 0020000000048800
FLASH ID : UNKNOW [Not In Base]
Boot Done!

   ===Flashing [MCU]===
File : rm732_004.550
Image : hw_s02_rm732_r04.550.fls
Cert block found, sending....
Cert sent
Found 3 region(s)
Processing Region 1/3
Erase , Start : 0x00000000 , Len : 0x00020000
Erasing, wait ... 
Erase done
Write , Start : 0x00000000 , Len : 0x00006000
Flashing , wait ...
Region flash done
Processing Region 2/3
Erase , Start : 0x00800000 , Len : 0x00400000
Erasing, wait ... 
Erase done
Write , Start : 0x00800000 , Len : 0x003F0000
Flashing , wait ...
Region flash done
Processing Region 3/3
Erase , Start : 0x00C5D000 , Len : 0x00203000
Erasing, wait ... 
Erase done
Write , Start : 0x00C5D000 , Len : 0x0019E700
Flashing , wait ...
Region flash done
Check : 722A
   ===Flashing [PPM]===
File : rm732_004.55ei
Image : hw_s02_rm732_004.55ei.fls
Cert block found, sending....
Cert sent
Found 1 region(s)
Processing Region 1/1
Erase , Start : 0x00100000 , Len : 0x00700000
Erasing, wait ... 
Erase done
Write , Start : 0x00100000 , Len : 0x0053BAC0
Flashing , wait ...
Region flash done
Check : 820E
   ===Flashing [CNT]===
File : rm7320_nai04.55ei
Image : hw_s02_rm7320_nai04.55ei.fls
Cert block found, sending....
Cert sent
Found 1 region(s)
Processing Region 1/1
Erase , Start : 0x00E60000 , Len : 0x00100000
Erasing, wait ... 
Erase done
Write , Start : 0x00E60000 , Len : 0x00081940
Flashing , wait ...
Region flash done
Check : 0400

Flashing done, rebooting...
-> Infineon info : Do FullFactory Sets after flashing
Flashing Done!


Init Service mode... Wait...

Afterflash settings...
SW ver : V 04.55
14-04-11
RM-732
(c) Nokia
IMEI   : xxxxxxxxxxx
PCode  : 
Settings After Flash Defaults...
FullFactorySet...OK!
ProductTuneSet...OK!
SwUpgradeSet...OK!
All done!

Connect phone on selected interface...

Phone found!
Series 40 Device detected! 
read info...  - Ok