Connect phone on selected interface...

Phone found!
Series 60 Device detected!
read info...  - Ok

Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SimLock Data found!
SimLock key found!
SuperDongle Key found!
CMLA key found!
WMDRM key found!
Setting FlashMode
FlashMode set Ok

1st boot Ok, C0

CMT part info : 
CMT ASICID   : 000000030000022600010007600C192102011104
CMT EM0 ID  : 00001040
CMT EM1 ID  : 00001030
CMT PUB ID  : 08E0001573690344B1B231C7E1C0415246450228
CMT MODE ID : 00
CMT R_HASH  : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID  : 3E273BF637BE26FA

CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg  ,  Rev : 0.0  Ver : 1.37.1 
CMT Loader sent, Boot Ok
MCU Configuration
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT   : 00000049010000000200611004000E00A80700
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg  ,  Rev : 0.0  Ver : 1.40.0 
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode :  Dual (Ddr, TX2) 

Boot Done!

Preparing for write certificates...

Switching to CMT... 

CMT : NPC erase Ok
Programming report : Error NPC
Programming report : Error NPC
Writing NPC... Ok

CMT : CCC erase Ok
Programming report : Error CCC
Programming report : Error CCC
Writing CCC... Ok

CMT : HWC erase Ok
Programming report : Error HWC
Programming report : Error HWC
Writing HWC... Ok

Init Service mode... Wait...

Check phone mode...
Phone in Local mode
Seting Test mode... wait...
Test mode set

Writing SimLock Key...   Error!
Writing SimLock Data...  Error!
Writing Super Dongle Key...   Ok

SDD Key status : SD Data is Ok
SimLock status : SimLock is Ok
Security status : Security Damaged!!!!! :(


Done!