Connect phone on selected interface...

Opening Connection... 
Device Location: 00000012
Connect Ok!
Initializing Connection...
JAF Firmware: 01.B6

JAF S/N ODJAF000 boot - Ok
Switch jaf to FBUS...
FbusMode set Ok

Connect phone on selected interface...

Phone found!
Series 60 Device detected!
read info...  - Ok

Core version : 1.20 , Rev : 4.0

Selected FlashSettings : 
Files Set for Flashing :
MCU : RM-504_32.0.007_prd.core.C00
PPM : RM-504_32.0.007_prd.rofs2.V05
PPM2 : RM-504_32.0.007_C01_prd.rofs3.fpsx
CNT : RM-504_32.0.007_007_000_U001.uda.fpsx
Checking BUS...
Switch jaf to FlashMode...
FlashMode set Ok
Booting phone...

BOOT 1ST   : C0

CMT part info : 
CMT ASICID   : 000000010000022600010006400C192101051105
CMT EM0 ID  : 00000296
CMT EM1 ID  : 00000B22
CMT PUB ID  : 03200108B49E00527F73549FB5442598B49546E8
CMT MODE ID : 00
CMT R_HASH  : B8C3ADECFC997FCD8081D3DEAF870B8C
CMT ROM ID  : 4B9B75103E691FF8

Change Protocol : NEW

Using NEW Flashing Protocol

CMT : Sending 2nd loader...
Use : RAPIDOv11_2nd.fg
CMT Loader sent, Boot Ok
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLIC : 00400020 , NAND , CMT

Sending Algo...
Use RAPIDOv11_XSR17_alg.fg
Finalize done, Algo sent!
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
PapubKeysReq : F2B05364E563A348608C1C3C9E54FE42AAAA1ACF80
Boot done!

CMT : Read NPC certificate...
IMEI : 358304035965130
CMT : Read CCC certificate...
CMT : Read HWC certificate...
Cert Read done!

NPC Certificate saved...
CCC Certificate saved...
HWC Certificate saved...

RPL saved : c:\InfinityBox\BEST\Backup\Cert\358304035965130_CRT_2nd.rpl


Checking BUS...
Switch jaf to FlashMode...
FlashMode set Ok
Booting phone...

BOOT 1ST   : C0

CMT part info : 
CMT ASICID   : 000000010000022600010006400C192101051105
CMT EM0 ID  : 00000296
CMT EM1 ID  : 00000B22
CMT PUB ID  : 03200108B49E00527F73549FB5442598B49546E8
CMT MODE ID : 00
CMT R_HASH  : B8C3ADECFC997FCD8081D3DEAF870B8C
CMT ROM ID  : 4B9B75103E691FF8

Change Protocol : NEW

Using NEW Flashing Protocol

CMT : Sending 2nd loader...
Use : RAPIDOv11_2nd.fg
CMT Loader sent, Boot Ok
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLIC : 00400020 , NAND , CMT

Sending Algo...
Use RAPIDOv11_XSR17_alg.fg
Finalize done, Algo sent!
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
PapubKeysReq : F2B05364E563A348608C1C3C9E54FE42AAAA1ACF80
Boot done!

SC : StoreCert Ok

Partitioning....
Partitioning Ok...
Erase : Processing RM-504_32.0.007_prd.core.C00
Init Erase Mode Ok
Found 2 data types
Erasing Data....
Erase area : 0x00040000 - 0x00082FFF , CMT , NAND
Erase area : 0x00083400 - 0x003FFFFF , CMT , NAND
Erase area : 0x00400000 - 0x007FFFFF , CMT , NAND
Erase area : 0x00800000 - 0x00D5FFFF , CMT , NAND
Erase area : 0x00D60000 - 0x09E5FFFF , CMT , NAND
Erase Ok...
Erasing Partition....
Partition 0x0A
Erase Ok...
TIME : Erase time : 00:00:01
Write : Processing RM-504_32.0.007_prd.core.C00
Init Write Mode Ok
CMT: Writing Hash CERT [ADA]
CMT: Writing Hash CERT [KEYS]
CMT: Writing Hash CERT [PRIMAPP]
CMT: Writing Hash CERT [RAP3NAND]
CMT: Writing Hash CERT [PASUBTOC]
CMT: Writing Hash CERT [PAPUBKEYS]
CMT: Writing Hash CERT [SOS*UPDAPP]
CMT: Writing Hash CERT [SOS*ENO]
CMT: Writing Hash CERT [SOS*DSP0]
CMT: Writing Hash CERT [SOS*ISASW]
CMT: Writing Hash CERT [SOS+CORE]
CMT: Writing Hash CERT [SOS+ROFS1]