Connect phone on selected interface...

UFS S/N xxxxx boot - Ok

Connect phone on selected interface...

Connect phone on selected interface...

Phone found!
Series 40 Device detected! 
read info...  - Ok

Reading Phone Info....
Connected phone -    Nokia 5130c-2
Software ver : V 06.65 01-04-09 RM-495 (c) Nokia            
IMEI    :      355xxxxxxxxxxxxx
Ape Ver :      
APE Var :      
APE ADSP:      
DSP Ver :      ICPR72_09w03
APE Test:      
PPM     :      V 06.65
01-04-09
RM-495
(c) Nokia            
EL
CNT     :      Content: el_blu
V 06.65
01-04-09
RM-495
(c) Nokia            

Product SN   :     0
Product code :     
Base Prd.code:     
Module code  :     
Long Prod.SN :     0
Hardware info=======
HWID  : 
Retu  : 16
Tahvo : 22
Batery: 4688 mV
Camera: 
CMT BT: 2222-143C
APE BT: 
APE HW: 
LCDVer: SEIKO
RF ic : 06540601
Lock info ===========
IMEI       : 355xxxxxxxxxxxx
IMEI spNet : 
IMEI svNet : 

Unable to read Lock table... :(
User code : Crypted
MMC pwd  : Backup saved
UserDataExLevel : Full [PhoneBook, Calendar, PWD, SMS, Gallery] 

Done!

Will Write RPL keys now...
Check RPL file...
NMP RPL Detected, converting...
Convert done!
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SimLock Data found!
SimLock key found!
SuperDongle Key found!
CMLA key found!
WMDRM key found!
Setting FlashMode
FlashMode set Ok

1st boot Ok, C0

CMT part info : 
CMT ASICID   : 000000010000022600010006030C192101033000
CMT EM0 ID  : 00000296
CMT EM1 ID  : 00000B22
CMT PUB ID  : 11600213220A7E56117DFCA35A5D43122A0BA1C7
CMT MODE ID : 00
CMT R_HASH  : 9DDBFCFE6E73CED7D8C6268C8EB85723
CMT ROM ID  : 273F6D55DFAAF68F

CMT : Sending 2nd loader...
Use : RAP3Gv3_2nd.fg  ,  Rev : 0.0  Ver : 10.42.0 
CMT Loader sent, Boot Ok
MCU Configuration
FLASHID : 89820089 , CMT , NOR
CMT Flash ID : 89820089 < INTEL => 0046L0Y1GG/NU48F512
FLCNT   : 00000000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAP3Gv3_algo.fg  ,  Rev : 0.0  Ver : 10.40.0 
CMT Algo sent
CMT PAPUB : 917F11196FDB7378C18EF7260698CA4489DCA02700
Transmission mode :  Dual (Ddr, TX2) 

Boot Done!

Preparing for write certificates...

Switching to CMT... 

CMT : NPC erase Ok
Programming report : Error 
Writing NPC... Ok

CMT : CCC erase Ok
Programming report : Error 
Writing CCC... Ok

CMT : HWC erase Ok
Programming report : Error 
Writing HWC... Ok

Init Service mode... Wait...

Check phone mode...
Phone already in Test mode, skip change...

Writing SimLock Key...   Error!
Writing SimLock Data...  Error!
Writing Super Dongle Key...   Ok

SDD Key status : SD Data is Ok
SimLock status : SimLock is Ok
Security status : Security Damaged!!!!! :(


Done!

Connect phone on selected interface...

Phone found!
Series 40 Device detected! 
read info...  - Ok

Reading Phone Info....
Connected phone -    Nokia 5130c-2
Software ver : V 06.65 01-04-09 RM-495 (c) Nokia            
IMEI    :      12345610654321?
Ape Ver :      
APE Var :      
APE ADSP:      
DSP Ver :      ICPR72_09w03
APE Test:      
PPM     :      V 06.65
01-04-09
RM-495
(c) Nokia            
EL
CNT     :      Content: el_blu
V 06.65
01-04-09
RM-495
(c) Nokia            

Product SN   :     0
Product code :     
Base Prd.code:     
Module code  :     
Long Prod.SN :     0
Hardware info=======
HWID  : 
Retu  : 16
Tahvo : 22
Batery: 4680 mV
Camera: 
CMT BT: 2222-143C
APE BT: 
APE HW: 
LCDVer: SEIKO
RF ic : 06540601
Lock info ===========
IMEI       : 12345610654321?
IMEI spNet : 
IMEI svNet : 

Unable to read Lock table... :(
User code : Crypted
MMC pwd  : Backup saved