TaiChi WhiteCap Software Flash Procedure
                                                             For Motorola Internal Use Only
 

1. Use MotoFLex 76 using the same flash procedure as Leap or LeapR through EMMI.
   Please refer to mf76_man.pdf for MotoFlex usage guide.

2. Use V42_48_01 or greater version for emmi2b(SLN3577C);
   Use V62_48_34 or greater version for emmi2d(SLN3577D).

3. TaiChi software CF.10.10 and greater versions can ONLY be used on TaiChi P10 or greater hardware.
Phone with software CF.09.10 or lower version is required to use flash_fdi.hex and do phasing.

4. If you do not have capability to do phasing, pls go through the following procedures maually instead.
Required software: HPBASIC and EEUTIL.19, 
Location: ate.zip, hpbasic.zip, /export/releases/internal/taichi/whitecap/flash/.
Usage: copy /ate directory to c: root directory.

1) Start HPBASIC and run E.19, read full eeprom info from phone, and save to a file, e.g. tc_p10
2) Flash CP+FDI to the phone, e.g. flash_fdi.hex
3) Modify the file you saved: open file tc_p10, change the version number (first line), then change the EEPROM Map Version number ( the line under EEPROM Map Version ) according to release notes.
4) Start HPBASIC and run E.19, write file tc_p10 back to phone's EEPROM