COM8 [VCP0] selected
module  v3.07
Device: Autodetect 6205-6227 NOR
Checking data, wait...
advanced flash detection enabled
Action: repair security area
====>  Boot ...
Press and HOLD Power button now !
19200 fixed
Connecting, wait...
Initializing [6225:8A03:8A00]...
CPU: MT6225
high speed boot On
chip: 0001:5903:0007
status: FF
boot packet size: 0400
Release Power button now !
Boot Done
====>  Initialize ...
detecting chip #00 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
detecting chip #01 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
detecting chip #02 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
detecting chip #03 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
number of flash chip/regions detected: 04/01
Initialize Done
====>  Set baud ...
460800
Set baud Done
====>  Initialize bootcode ...
Initialize bootcode Done
====>  Check firmware integrity ...
device parameters detection in progress...
detecting chip #00 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
detecting chip #01 in region #00...
flash: 98000300000000:18A59F00000000
flash: Toshiba AMD/Fujitsu std [T 0008x004000 007Fx020000] 16Mb
it's time to stop: 18B09FA518B09FA518B09FA518B09FA518B09FA518B09FA5
number of flash chip/regions detected: 01/01
total flash region size: 01000000
usb bootloader detect...
..
usb bootloader detect (phase #2)...
..
usb bootloader (chip) is absent
searching rom info...
.
search rom info finished
searching rom info...
.
search rom info finished
warning: rom info information not found, possible reasons:
- old firmware type w/o rom info information
- empty (completely or partially erased) flash chip
- damaged firmware
- damaged hardware (bad soldered or damaged flash chip)
> if phone works fine just ignore this warning <
detecting startup code area #2...
................................................................................................................................................................................................................................................................
startup code area #2 is absent
sec info (fast) detection...
searching sec info#1...
.
search sec info#1 finished
error: incorrect ffs address range
Finished, time used: 1 min 12 sec
Remove/Install battery now !