KMQNW000SM-B316 EMMC NAME: 000000

[aziz]

KMQNW000SM-B316 есть ли вариант, исправит name на этом emmc?

eMMC Device Information
EMMC CID : 150100303030303030562012063058CE
EMMC CSD : 902701320F5903FFF6DBFFEF8A404022
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 05/2005 Rev.0x56
EMMC NAME: 000000 , S/N: 538052144
EMMC NAME (HEX): 30303030303000

[valdiska]

А если через firmware update самой флешки с помощью z3x easy jtag

[aziz]

Появился у меня новый KMQNW000SM-B316. Сливал dump, при записи выдает следующие.

Running:SAMSUNG: eMMC firmware update...
Confirmed eMMC Part Number: KMQNW000SM-B316
Z3X EasyJtag Software ver. 2.1.1.1
Loading eMMC Addon Firmware... IO: 3300 mV
Box S/N: 13130E0996424D5E, ,FW Ver.: 01.55
CMD Pullup Level:2124 mV
CMD Active Level:3062 mV
Box IO Level:3300 mV
CLK Rate:14000 khz
Setup firmware update mode, wait 2..30 sec...
Success!
Sending eMMC firmware...
Can't send eMMC firmware, Reason: DATA Status Error [Box Internal Failure]
Done.

[Ewind]

Я брал дамп из другого источника, но результата нет. После заливки прошивки контроллер по-прежнему в режиме восстановления прошивки...
Z3X EasyJtag Software ver. 2.1.1.1
Loading eMMC Addon Firmware... IO: 1800 mV
Box S/N: 050506XXXXXXXXX, ,FW Ver.: 01.55
CMD Pullup Level:1856 mV
CMD Active Level:2134 mV
Box IO Level:1800 mV
CLK Rate:14000 khz
HiPower™ mode is off!
eMMC Device Information
EMMC CID : 150100303030303030562012063058CE
EMMC CSD : 902701320F5903FFF6DBFFEF8A404022
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 05/2005 Rev.0x56
EMMC NAME: 000000 , S/N: 538052144
EMMC NAME (HEX): 30303030303000
EMMC ROM1 (Main User Data) Capacity: 8192 MB
EMMC ROM2 (Boot Partition 1) Capacity: 512 kB
EMMC ROM3 (Boot Partition 2) Capacity: 512 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00]
Partitioning Support [PARTITIONING_SUPPORT]: 0x03
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: 000000_ 538052144_20160606_2209.extcsd
Done.

Running:SAMSUNG: eMMC firmware update...
Confirmed eMMC Part Number: KMQNW000SM-B316
Z3X EasyJtag Software ver. 2.1.1.1
Loading eMMC Addon Firmware... IO: 1800 mV
Box S/N: 050506XXXXXXXXXX, ,FW Ver.: 01.55
CMD Pullup Level:1856 mV
CMD Active Level:2155 mV
Box IO Level:1800 mV
CLK Rate:14000 khz
Setup firmware update mode, wait 2..30 sec...
Success!
Sending eMMC firmware...
Success!
Verifying eMMC firmware...
Success!
Flashing eMMC firmware...
Success!
Repairing eMMC CID...
Success!
eMMC firmware is updated now!
Please reconnect all eMMC lines before next operation!
Please don't forget to repair extCSD from backup!
Please don't forget to configure BOOT sizes!
Done.

Z3X EasyJtag Software ver. 2.1.1.1
Loading eMMC Addon Firmware... IO: 1800 mV
Box S/N: 050506XXXXXXXXXX, ,FW Ver.: 01.55
CMD Pullup Level:1815 mV
CMD Active Level:2134 mV
Box IO Level:1800 mV
CLK Rate:14000 khz
HiPower™ mode is off!
eMMC Device Information
EMMC CID : 150100303030303030562012063058CE
EMMC CSD : 902701320F5903FFF6DBFFEF8A404022
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 05/2005 Rev.0x56
EMMC NAME: 000000 , S/N: 538052144
EMMC NAME (HEX): 30303030303000
EMMC ROM1 (Main User Data) Capacity: 8192 MB
EMMC ROM2 (Boot Partition 1) Capacity: 512 kB
EMMC ROM3 (Boot Partition 2) Capacity: 512 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00]
Partitioning Support [PARTITIONING_SUPPORT]: 0x03
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: 000000_ 538052144_20160606_2211.extcsd
Done.
Дамп выше скачать нет прав, прикреплю скачанный на стороннем ресурсе и прошивку на основе него.
Если есть возможность, отправьте мне Ваш дамп, попробую что с ним выйдет.

[aziz]

Уже нет желания с ним возится. Из поддержки молчать, создал тему даже соседнем форуме. Саня последняя время вообще не отвечает.

[Kapetz]

Есть подтяжки 16k на cmd и dat0-7 ?