Пост в стадии разработки - не пинайте сильно :kn::kos:
1 - разблокируем через офф сайт bootloader (http://www.htcdev.com/bootloader/)
2 - получаем супер CID 111111 (http://forum.xda-developers.com/showthread.php?t=2264322)
You can get your actuall cid with this fastboot cmd:
Code:
fastboot oem readcid
Result for me: HTC__102
How to:
Open cmd window where your adb is located.
There you make the following commands one after the other:
Code:
adb shell
Code:
su
Code:
dd if=/dev/block/mmcblk0p4 of=/sdcard/mmcblk0p4.img
Code:
exit
Code:
exit
Code:
adb pull /sdcard/mmcblk0p4.img
Now your bootloader is extracted to SD card, then into your adb folder.
Look at the file size of mmcblk0p4.img, it MUST be the same size after changing the cid! Don't flash it back, if it isn't the same size.
Now open the mmcblk0p4.img with Hex-Editor and look, where your cid is located (on my picture it is HTC__102). Afterwards it is followed by your IMEI number.
Don't forget to check the filesize!
Back to command line you have to make the following commands one after the other:
Code:
adb push mmcblk0p4.img /sdcard/mmcblk0p4MOD.img
Code:
adb shell
Code:
su
Code:
dd if=/sdcard/mmcblk0p4MOD.img of=/dev/block/mmcblk0p4
Code:
exit
Code:
exit
Code:
adb reboot bootloader
Now you can check your new supercid with the fastboot command:
Code:
fastboot oem readcid
The result should be 11111111
3- S-off (http://forum.xda-developers.com/showthread.php?p=39470025)
1.) Download patcher and unzip it in your working directory:
soffbin3.zip http://androidfiles.org/getdownload....U/soffbin3.zip
2.) Download zip that matches your model and move it in your working directory (do not unzip it!):
K2U http://androidfiles.org/getdownload....le=K2U/rom.zip
K2PLC_CL http://androidfiles.org/getdownload...._PLCCL/rom.zip
K2_UL http://androidfiles.org/getdownload....=K2_UL/rom.zip
3.)
Code:
adb reboot bootloader
(wait for bootloader)
4.)
Code:
fastboot oem rebootRUU
(wait for black HTC Screen)
5.)
Code:
fastboot flash zip <appropriate zip filename from above>
After a while, You should see the following error “FAILED (remote: 92 supercid! please flush image again immediately)”
6.) Immediately issue the following command:
Code:
fastboot oem boot
You may see some errors, just wait for the device to boot into Android (only now, you should be booted into Android with no eMMC write protection of any kind active).
7.) Issue the following 3 commands to update the security partition with S-off flags (one command at a time!):
Code:
adb push soffbin3 /data/local/tmp/
adb shell chmod 744 /data/local/tmp/soffbin3
adb shell su -c "/data/local/tmp/soffbin3"
(wait for a few seconds)
8.)
Code:
adb reboot bootloader
9.) You should see what you are looking for!
4 прошиваем кастом рекавери
5 делаем на данной стадии бекап системы
6 льем прошивки https://www.dropbox.com/s/jm7c34c26kc70kb/crystalist_v2.0_stable.zip
итак после продолжительного мытарства имеем
< waiting for device >
(bootloader) version: 0.5
(bootloader) version-bootloader: 1.01.0000
(bootloader) version-baseband: 1.12.00.1210_2
(bootloader) version-cpld: None
(bootloader) version-microp: None
(bootloader) version-main:
(bootloader) version-misc: PVT SHIP S-OFF
(bootloader) serialno: HT319S700063
(bootloader) imei: 355195000000010
(bootloader) product: k2_plc_cl
(bootloader) platform: HBOOT-8930
(bootloader) modelid: PL8010000
(bootloader) cidnum: 11111111
(bootloader) battery-status: good
(bootloader) battery-voltage: 3780mV
(bootloader) partition-layout: Generic
(bootloader) security: off
(bootloader) build-mode: SHIP
(bootloader) boot-mode: FASTBOOT
(bootloader) commitno-bootloader: 385cbc75c11643262fad3fa7dcb3bb7a745d5a7
Но при включении пишет PUK заблокирован обратитесь к оператору - это при вставленной сим - сети нема - в меню пункта моб сети нема -
курим далее