Onda V703 не включается, подозрение на ПО
#1
Внеше и внутри все ровно. ПК не определялся пока не закоротил 5 и 6-й пины на флешке.
Процессор AmLogic AML5726.
Нашел похожую прошивку V703D_v2.1_v3-0926.
Софт USB-Burning-tool-v1.6.22, если пины закоротить и отпустить прошивает до 16%, затем планшет "отваливается" и больше не цепляется программой, и программа выдает ошибку.
Код:
W/ [P7][19:58:25]Loading spl ... W/ [P7][19:58:25]Transfer Complete! total size is 19028 Bytes
W/ [P7][19:58:27]Transfer Complete! total size is 554720 Bytes
W/ [P7][19:58:45]After load uboot, disconnect, mBurnWaitCount: 9
W/ [P7][19:58:48]After load uboot, disconnect, mBurnWaitCount: 12
W/ [P7][19:58:50]wait uboot run ,scan system again!!!
W/ [P7][19:58:51]After load uboot, disconnect, mBurnWaitCount: 15
W/ [P7][19:58:54]After load uboot, disconnect, mBurnWaitCount: 18
W/ [P7][19:58:57]After load uboot, disconnect, mBurnWaitCount: 21
W/ [P7][19:59:00]After load uboot, disconnect, mBurnWaitCount: 24
W/ [P7][19:59:03]After load uboot, disconnect, mBurnWaitCount: 27
W/ [P7][19:59:06]After load uboot, disconnect, mBurnWaitCount: 30
W/ [P7][19:59:09]After load uboot, disconnect, mBurnWaitCount: 33
F/ [P7][19:59:11]wait uboot run failed 35 so make it disconnected
E/ [P7][19:59:12]failed because no connected device ,current step is 4
Если продолжать коротить то после 16%, аппарат отваливается и снова цепляется, прошивка идет дальше до 76%, отваливается, в системе появляется запоминающее устройство, программа долго думает, затем вываливается ошибка.
Код:
W/ [P7][19:59:59]Loading spl ... W/ [P7][20:00:00]Transfer Complete! total size is 19028 Bytes
W/ [P7][20:00:05]Transfer Complete! total size is 554720 Bytes
W/ [P7][20:00:11]Cmd --> (set_chgcur 0)(0)
W/ [P7][20:00:12]Cmd --> (video dev bl_off)(0)
W/ [P7][20:00:13]Cmd --> (video dev disable)(0)
W/ [P7][20:00:16]Cmd --> (sf probe 2)(0)
W/ [P7][20:00:17]Cmd --> (sf erase 0 100000)(0)
W/ [P7][20:00:17]Cmd --> (nand rom_protect off)(0)
W/ [P7][20:00:18]Cmd --> (nand scrub 0)(0)
W/ [P7][20:00:18]Cmd --> (nand info)(0)
W/ [P7][20:00:18]Cmd --> (defenv)(0)
W/ [P7][20:00:19]Cmd --> (setenv bootargs ${bootargs} a9_clk_max=600000000)(0)
W/ [P7][20:00:19]Cmd --> (setenv recovery_command --usb_burning)(0)
W/ [P7][20:00:19]Cmd --> (save)(0)
W/ [P7][20:00:21]Transfer Complete! total size is 4233216 Bytes
W/ [P7][20:00:22]Cmd --> (bootm 0x82000000)(0)
E/ [P7][20:04:21]failed because no connected device ,current step is 19
Последние файлы
