Re: Pantech (Sky) A760S после кастом прошивки упал в QDLoader 9008.
#3
При восстановлении этими файлами висит до бесконечности qpst, на счет jtag, телефон видит riff но ничего не считывает и не пишет, хотя без проблем стирает.
Цитата:
Connecting to the dead body...OK
Detected dead body ID: 0x104200E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is 1 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0000 (KYL00M, 0x0003AB400000 Bytes = 14.68 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0000 (KYL00M, 0x000000080000 Bytes = 0.50 MB)
Flashing the dead body...
ERROR: Timeout while waiting for DCC Loader response. Trying to recover...FAILED
ERROR: Failed due to multiple communication errors. Terminating at 0x000000000000
|
В pinout отсутствует rtck, у кого есть gpg или ort jtag посмотрите пожалуйста какой там jtag pinout.