Iphone F075 не могу залить прошивку.
#1
Код:
COM2 [VCP0] selected
module v3.29
Device: Autodetect 6228-6268 NAND
Checking data, wait...
Action: write flash NAND
write: Firmware
editor_corrected_L075_ML_PCB01_GPRS_MT6235B_S01.L075_ML_TY1G_GPS_WF1_TV1_EN_V2_06__fullflash_20110412-130443.B4M.bin.B4M.bin
skip: Customization/Language Pack
skip: Customization
skip: Eeprom/ffs
nfi area detection...
nfi scat area detected (3 areas)
nfi area detection (3 cores) finished: Ok
interface: BROM_DLL_v3.1016.00
Connect...
Phone should be Switched OFF !
Press and HOLD Power button now !
Connecting...
Booting...
Release Power button now !
bootcode current/expected: 3.2/3.2
CPU: 6235:8A04:8A01
status: FF
bbchip bl ver: FE
NOR flash chip: not installed
NAND flash id[0014]: 0098:00D100900015 [TOSHIBA] TC58NVG0S3AFT
chip size: 128Mb
page/spare size: 0800/0040
pages per block: 0040
bits i/o: 08
address cycles: 04
internal RAM size: 00010000
external RAM: S_DA_RAM_ERROR
done
Set baudrate (230400)...
done
ram test...
testing 32bit...
32bit ram test passed
testing 16bit...
16bit ram test passed
ram test passed
===> detect existing firmware structure...
detect ffs...
ffs offset/size: 02000000/06000000
firmware size: 32Mb
ffs size: 96Mb
detect sec ro...
detect custom parameters...
detect project-id...
project-id: L075_ML_TY1G_GPS_WF1_TV1_EN_V2.06
detect NAND info...
number of areas/bytes to read: 1:001A0000
reading (HW_STORAGE_NAND NUTL_READ_PAGE_ONLY)...
nfi area detection...
bootloader version: L075_ML_BOOTLOADER_V005_MT6235B_L075_ML_TY1G_GPS_WF1_TV1_EN_V2_0
warning: id-page1 area is invalid
nfi area detection (0 cores) finished: failed
TCL-ID detection...
TCL-ID detection done
startup code area #1 detection...
startup code area #1 detection done
rom info ver: 07
sw version: L075_ML_PCB01_GPRS_MT6235B_S01.L075_ML_TY1G_GPS_WF1_TV1_EN_V2_06.BIN
project-id: L075_ML_TY1G_GPS_WF1_TV1_EN_V2.06, 00000000
code offset: 00000000
ffs offset/size [01]: 02000000/06000000
rom info structure: [standard] type (07)
TCL-ID is absent
===> done
====================
New firmware found (v.3.29, database date: 04.04.2011):
L075_ML_PCB01_GPRS_MT6235B_S01.L075_ML_TY1G_GPS_WF1_TV1_EN_V2_06.BIN
This firmware is missing in support area. If this phone is good and working:
- download latest software from support area and try again, probably this firmware already supported in latest software
- make "Read full flash" operation
- send flash backup files to support: [email protected] or upload files to http://rapidshare.com or http://4shared.com
- include in your e-mail full text from phone back label (phone name etc.)
====================
nfi area detection...
nfi scat area detected (3 areas)
nfi area detection (3 cores) finished: Ok
startup code area #1 check...
done
number of cores: 3
loading files...
number of areas: 3
done
write...
write bootloader...
.
.
.
.
.
.
.
.
write core...
error: can not write flash (2): 0FAF:S_FT_NFB_DOWNLOAD_CODE_FAIL
error: last error: 0FAF:S_FT_NFB_DOWNLOAD_CODE_FAIL
Disconnect...
done
Finished, time used: 7 min 9 sec
Remove/Install battery now !
Собственно сабж. Причем из трех разных аппаратов на 6235 ни один удачно не прошился. Есть у кого идея в чем может быть проблема?