Jonic77
30.03.2017, 15:51
Testpoint Xiaomi Redmi Note 3 Pro
http://en.miui.com/data/attachment/forum/201603/20/235834ytz0829mcse0gj14.jpg.thumb.jpg
If fully hard bricked, you have to disassemble your phone and use test point to get EDL mode.
* Disconnect all the cables and flat cables
* Reconnect only Battery Display and USB
* Connect the phone to PC, open Mi Flash and load the ROM.
* Then short the points now your device should detect as EDL mode "Qualcomm HSUSB QLoader 9008"
Flashing Method By Mi Flash Tool:
* Extract the firmware.
* Run mi flash tool and show the path where you extracted the firmware folder.
* Goto Advance tab and select files lik gvn in the below image.
оригинал темы (http://forum.gsmdevelopers.com/f260/xiaomi-note-3-note-3-pro-unbrick-bootloader-unlock-firmware-guides-%5Bqualcomm%5D-2495/)
Если устройство не включается, разберите его и замкните тестпоинт для получения EDL режима:
* Отсоедините все шлейфы
* Переподключите только АКБ, дисплей и USB
* Соедините телефон с PC , запустите MiFlash и выберите в программе файл прошивки
* Коротко соедините теспоинт и Ваше устройство будет обнаружено в режиме "Qualcomm HSUSB QLoader 9008" - EDL mode
http://en.miui.com/data/attachment/forum/201603/20/235834ytz0829mcse0gj14.jpg.thumb.jpg
If fully hard bricked, you have to disassemble your phone and use test point to get EDL mode.
* Disconnect all the cables and flat cables
* Reconnect only Battery Display and USB
* Connect the phone to PC, open Mi Flash and load the ROM.
* Then short the points now your device should detect as EDL mode "Qualcomm HSUSB QLoader 9008"
Flashing Method By Mi Flash Tool:
* Extract the firmware.
* Run mi flash tool and show the path where you extracted the firmware folder.
* Goto Advance tab and select files lik gvn in the below image.
оригинал темы (http://forum.gsmdevelopers.com/f260/xiaomi-note-3-note-3-pro-unbrick-bootloader-unlock-firmware-guides-%5Bqualcomm%5D-2495/)
Если устройство не включается, разберите его и замкните тестпоинт для получения EDL режима:
* Отсоедините все шлейфы
* Переподключите только АКБ, дисплей и USB
* Соедините телефон с PC , запустите MiFlash и выберите в программе файл прошивки
* Коротко соедините теспоинт и Ваше устройство будет обнаружено в режиме "Qualcomm HSUSB QLoader 9008" - EDL mode