VictorMobium
24.06.2012, 14:59
При подключении от блока реакция на кнопку 40 мА, со слов клиента - лег при обновлении прошивки.
Лог Riff:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the dead body...OK
Set I/O Voltage reads as 3.30V, TCK Frequency is 8 MHz
Detected dead body ID: 0x0692602F
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the target...OK
Set I/O Voltage reads as 3.30V, TCK Frequency is 8 MHz
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x6201C05E, IR Length = 0x02 bits
Device on TAP #1: ID = 0x0D24C05E, IR Length = 0x03 bits
Device on TAP #2: ID = 0xFFFFFFFE, IR Length = 0x02 bits
Device on TAP #3: ID = 0xFFFFFFFF, IR Length = 0x01 bits
Device on TAP #4: ID = 0xFFFFFFFF, IR Length = 0x04 bits
Device on TAP #5: ID = 0xFFFFFFFF, IR Length = 0x04 bits
Total IR length: 0x0010 bits
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the dead body...OK
Detected dead body ID: 0x0692602F - CORRECT!
Set I/O Voltage reads as 3.30V, TCK Frequency is 12 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...FAILED
ERROR: RAM memory selftest failed.
Со скоростями и длинной проводов игрался.
Лог Riff:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the dead body...OK
Set I/O Voltage reads as 3.30V, TCK Frequency is 8 MHz
Detected dead body ID: 0x0692602F
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the target...OK
Set I/O Voltage reads as 3.30V, TCK Frequency is 8 MHz
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x6201C05E, IR Length = 0x02 bits
Device on TAP #1: ID = 0x0D24C05E, IR Length = 0x03 bits
Device on TAP #2: ID = 0xFFFFFFFE, IR Length = 0x02 bits
Device on TAP #3: ID = 0xFFFFFFFF, IR Length = 0x01 bits
Device on TAP #4: ID = 0xFFFFFFFF, IR Length = 0x04 bits
Device on TAP #5: ID = 0xFFFFFFFF, IR Length = 0x04 bits
Total IR length: 0x0010 bits
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [HTC Elf V1.00]
Connecting to the dead body...OK
Detected dead body ID: 0x0692602F - CORRECT!
Set I/O Voltage reads as 3.30V, TCK Frequency is 12 MHz
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...FAILED
ERROR: RAM memory selftest failed.
Со скоростями и длинной проводов игрался.