PDA

Просмотр полной версии : ENOL запчасти


alter
26.12.2005, 20:08
Народ!
Подскажите где их брать на эту марку?
Все обыскал.. :(
А телефоны несут, в основном со шлейфами...

GreyDog
27.12.2005, 01:20
alter, ничего дельного не скажу. Просто мысли в слух. Точнее рассуждения.
Я слышал они на самсунги похожи, даже платформа одна (Skyworks). Не пробовал сравнивать?
---
Вот нашел "Немного сервис-мануалов на ENOL" (http://www.mobile-files.ru/forum/showthread.php?forumid=707&threadid=45497). Попробуй скачать и сравнить. Я возьму на E200, посмотрю. К сожалению на все денег не хватит, баланс невелик и GPRS кусаеЦа...
---Display The E52FD uses two LCD, the color main LCD and gray sub LCD. The main display is a 65K STN(Super Twisted Nematic) Color Transflective LCD module running on 2.8V logic. The active area consists of 128(horizontal) by 128(vertical) pixels.

The display controller is a S1D15G10, which among others has internal temperature compensation. Other compatible controllers may be available (e.g. Samsung or Seiko-Epson).

To control the LCD module the controller(S1D15G10) is controlled by the BP with a parallel interface(8 bit parallel bi-directional bus, 1 chip selection input, 1 register selection input, 1 reset input, 1 backlight on/off control input, 1 write strobe input, 1 read strobe input, VCC and GND). When using the parallel interface it is possible to write and read the registers in the LCD controller.

The sub display is a FSTN(Filtered Super Twisted Nematic) Transflective LCD module running on 2.8V logic. The active area consists of 110(horizontal) by 20(vertical) pixels and some icons.

The display controller is a S1D10605 from Seiko-Epson, which among others has external temperature compensation. Other compatible controllers may be available (e.g. Samsung or Solomon).

To control the LCD module the controller(S1D10605) is controlled by the BP with a parallel interface(8 bit parallel bi-directional bus, 1 chip selection input, 1 register selection input, 1 reset input, 1 backlight on/off control input, 1 write strobe input, 1 read strobe input, VCC and GND). When using the parallel interface it is possible to write and read the registers in the LCD controller. Вот :) Я не силен в английском, но слово Samsung разобрал. Удачи.